Die Casting Mold Design And Die Casting Process
Die casting mold is important to process equipment in die casting production. The molten metal is cooled and solidified in the die-casting mold, and finally,
Introduction to Plastic Die Casting
In the die casting process, the thermosetting resin material is added to a separate material cavity, often called a material tank, and then forced into one
Quality Control Measures for Production Process of Die Casting – Maintenance of Casting Equipment
Maintenance of die casting equipment 1. All die-casting equipment should be used in strict accordance with the equipment operating regulations. 2. For the daily maintenance and maintenance,
Quality Control Measures for Production Process of Die Casting – Recycled Material
1. In the process of die-casting production, the operator is strictly prohibited from putting back furnace materials (such as defective products, slag collecting bags, etc.) into
Quality Control Measures for Production Process of Die Casting – Aging Treatment of Die Casting
Aging treatment of die castings 1. All die-casting parts must undergo aging treatment to eliminate the die-casting stress of the product. 2. The die-casting parts produced in
Quality Control Measures for Production Process of Die Casting – Raw Material Testing
1. All purchased aluminum ingots must be tested by physical and chemical laboratories. Only qualified aluminum ingots can enter the die-casting workshop for trial die-casting.
Quality Control Measures for Production Process of Die Casting – Process Control
Matters needing attention in process control 1. Key processes should be controlled in key. 2. For die-casting parts that are prone to product deformation due
Quality Control Measures for Production Process of Die Casting – Quality Control
Full inspection of the product 1. All inspectors conduct all inspections on the die-cast products. 2. Mainly inspect the appearance and defects of products. 3.
Quality Control Measures for Production Process of Die Casting – Production Inspection
Confirmation and assembly of die casting mold 1. The team leader must confirm the conformity of the mold model to be used for assembly, and
